Hello How to cut a stencil on a sheet of A3. I changed in file graphtec.py self.media_size = (12,11) on self.media_size = (12,24) But cutter wants to cut stencil longer than 15 ". All apertures below 15" are ignored and are not cut. Please, help!
Offset from the edge on each side consists of the parameter "offset" + "border". I had to begin to plotter cut stencils from the right upper corner. So I set the parameter offset = (0.1,0.1). The format is specified in a file graphtec.py
# Page = ["12x12 cutting mat", 6096, 6096] # 12x12 cutting mat in device units page = ["12x11 media", 6096, 5588] # 12x11 media in device units
I found the answer to my question. Start cutting out the stencil indicated in "offset". I have the following question - how to disable cut border around stencil?
I have a Silhouette CAMEO cutting plotter with 12 "cutting mat. I use it for cutting stencils. Help me configure plotter to cut the film 300x300 mm. I use g2g_gui, operating system windows XP
does not work I run a python.exe and write command: C:gerber2graphtec-mastertest_calibrate.py > \Loracameo or C:test_calibrate.py > \Loracameo After starting getting the message: SyntaxEerror: invalid syntax What am I doing wrong?
