Skip to main content

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - DeKay

1
Client software / Re: OLS client 0.9.4 RC1
I tried 0.9.4 rc1 on Arch Linux and found that the I2C protocol analyzer doesn't remember the settings (bit order, pin assignments, mode) between one analysis and the next.  This worked fine in 0.9.3.  No errors are reported on the console.
2
Client software / Units for Delay in the Trigger Window?
Can someone confirm that the Delay in the trigger menu is in units of cycles at the sampling rate?  So 2 MHz samples rate with a delay of 1,000,000 would be a half second delay?  And what is the maximum delay I can specify?  I might need some very long delays to capture the information I need as a device comes out of reset.