This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.
Messages - ammas09
I know this is a little off topic but is this the same case for AVR?
What it seems like, I use MPLAB and generate a hex (from C or whatever language) and then use another program to load this hex into the PIC. I thought I downloaded the correct program for this from the link above but whenever I launch it is just disappears instantly.
Could I be using the wrong download, I don't know if there is an IDE or something I should be using for this? Would there happen to be a tutorial that might cover this somewhere?
Thanks for your hello, sorry about being such a noob.
1. can I program newer PIC's without the bus pirate pic programmer board (the extra board that sits on top)
2. Can I write code in C with MPLAB and then compile and send it to my PIC using the bus pirate?
3. If so how do I go about doing this, do I need to download drivers or something like that?
In short I want to write C code, and send it to my PIC chips with the bus pirate. I just don't know how or even if I can.
Thanks in advance.
(I apologize if this is already addressed, I have been looking for a couple days now and can't seem to find an answer)