Skip to main content

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - F43nd1r

USB Infrared Toy / Irtoy shows up as CDC Test device
I've had my IRToy working perfectly fine under arch linux using lirc until a few days ago.
Now it doesn't respond to commands.
I think the problem is the device mode, it show up as CDC Test:
Code: [Select]
$ dmesg
[ 2192.353572] usb 5-2.1: new full-speed USB device number 9 using xhci_hcd
[ 2192.456094] usb 5-2.1: New USB device found, idVendor=04d8, idProduct=fd08, bcdDevice= 0.02
[ 2192.456097] usb 5-2.1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 2192.456098] usb 5-2.1: Product: CDC Test
[ 2192.456100] usb 5-2.1: Manufacturer: Dangerous Prototypes
[ 2192.456101] usb 5-2.1: SerialNumber: 00000001
[ 2192.519651] ir_toy 5-2.1:1.1: version: hardware 2, firmware 22, protocol 1
[ 2192.519657] Registered IR keymap rc-rc6-mce
[ 2192.519679] rc rc0: Infrared Toy as /devices/pci0000:00/0000:00:07.1/0000:0c:00.3/usb5/5-2/5-2.1/5-2.1:1.1/rc/rc0
[ 2192.519722] rc rc0: lirc_dev: driver ir_toy registered at minor = 0, raw IR receiver, raw IR transmitter
[ 2192.519763] input: Infrared Toy as /devices/pci0000:00/0000:00:07.1/0000:0c:00.3/usb5/5-2/5-2.1/5-2.1:1.1/rc/rc0/input36

There is no /dev/ttyACM0 device, but instead a /dev/input/by-id/usb-Dangerous_Prototypes_CDC_Test_00000001-event-if01 device.

I've already tried to reflash the firmare, which worked but didn't change my situation. Does anyone know how to fix this or is there anything else I could try?