1
Project logs / Re: Really universal soldering controller
You should replace Ra .. Rg with 0ohm resistor or just short pads with solder.
[/quote]
I've actually added a note that appears below, when R[a-g] is selected, I might edit it to make the 47 ohm value disappear completely to avoid confusion.
[quote author="WSlomo"]
DS1(firs row of solder jonts ) and DS3(last row of solder jonts) should be replaced with gold pin sockets. DS2 should be removed.
[/quote]
Good idea, i will make an update once I am able too and make a special note appear when clicked that states how should the OLED be inserted as well as the lack of support for LED displays by the firmware.
[quote author="WSlomo"]
Q15, Q17 should be also removed.
[/quote]
I've added notes in regards to these (when these are clicked on or found by typing the designator, a note appears below and tells that they shouldn't be installed).
[quote author="WSlomo"]
Could you also add second side of front PCB and mark pads that you need to short with solder.
[/quote]
Sure, I'll add it with the next release!
[quote author="salavat"]
Great tool, helped me a lot in assembling Unisolder. The first version had couple errors as compared to BOM (caps value was incorrect the one I remember), I do not remember which exactly. Have they been fixed in this one?[/quote]
Since I've completely remapped the components, the wrong values should be gone (the only thing that is the same, are the javascript search functions from the original unisolder-chips, everything else was changed).
