Skip to main content

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - Contemplator

Project logs / Re: 900M/T12/JBC + heat gun soldering controller
Use external sensorTC1047A. Sensor output connects to PA4 on 3-channel controller. Firmware Nov 24, 2017. What are the values of corTcold and setTcold that must be selected for the operation of an external temperature sensor?
Project logs / Re: 900M/T12/JBC + heat gun soldering controller
Hello projector 42, I purchased display http://,searchweb201602_2_10065_10068_433_434_10136_10137_10138_10060_10062_10056_10055_10054_302_10059_10099_10103_10102_10096_10052_10053_10050_10107_10051_10106_10084_10117_10083_10119_10080_10082_10081_10110_10111_10112_10113_10114_10078_10079_10073_10070_10122_10123_10120_10126_6000000_10127_10124_10125,searchweb201603_1,afswitch_1_afChannel,ppcSwitch_7,single_sort_0_default&btsid=4982e2c6-fc95-4e32-8609-ba86a842a91e&algo_expid=a62e4c0a-f5c6-46d8-a7da-c5173458c2f6-36&algo_pvid=a62e4c0a-f5c6-46d8-a7da-c5173458c2f6 But its i2c scanner is located at the address 0x3C (Arduino checked). Can I do something about this?