1
Show Posts
This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.
Messages - TheChuckster
2
Bus Pirate Support / Re: Promoting dead project Bus Pirate
3
Bus Pirate Support / Firmware flash always unsuccessful, ERROR after so many page
Code: [Select]
chuck@excelsior ~/Bus_Pirate/BPv4-bootloader/pirate-loader $ sudo ./pirate-loader --dev=/dev/ttyACM0 --hex=/home/chuck/Downloads/bp4.0-fw-7.0.hex
+++++++++++++++++++++++++++++++++++++++++++
Pirate-Loader for BP with Bootloader v4+
Loader version: 1.0.3 OS: Linux
+++++++++++++++++++++++++++++++++++++++++++
Parsing HEX file [/home/chuck/Downloads/bp4.0-fw-7.0.hex]
Found 30070 words (90210 bytes)
Opening serial device /dev/ttyACM0...OK
Configuring serial port settings...OK
Sending Hello to the Bootloader...OK
Bootloader version: 4,06
Device ID [f1]:PIC24FJ256GB106
Erasing page 0, 0000...OK
Writing page 0 row 0, 0000...OK
Writing page 0 row 1, 0080...OK
Writing page 0 row 2, 0100...OK
Writing page 0 row 3, 0180...OK
Writing page 0 row 4, 0200...OK
Writing page 0 row 5, 0280...ERROR
Error updating firmware :(
Happens every time, except at a different failure point (I've seen it go up to page 11, page 15).
This is a REAL headache, not only does it ship with an unstable firmware out-of-the-box, I can't update it!
I've tried removing the jumper after booting it and pressing the Normal and Reset buttons in various combinations as suggested by other forum members, without success...