Try to distinguish if it is a software or hardware problem. you can increase "Standby" as it could because once it gets to that "Z z z, ..." the only way to come out is to repower the Unisolder.
Si infatti è così. Per il momento ho sostituito il micro switch (mia modifica) che mette lo stilo in st.By, e per ora il difetto sembra scomparso
Hello everyone! I assembled my Unisolder 5.2, everything works, but I found the following problem. If during operation with the JBC C-245 the green cable (Outer shell to SenseB) breaks for some reason or the connection becomes loose, the station begins to heat up the tip uncontrollably until it turns RED. I think this is quite dangerous. Have any of you had this problem? The cables on the handle are quite thin and it is possible for one of them to break, as in my case. I want to know if this is an error in my assembly or if there is simply no protection provided for such cases... Thanks!
Ho lo stesso problema ha distrutto 2 punte C245, ma non so se è il connettore . Il difetto è saltuario difficile da prevedere
Long time use Unisolder with Jbc 2245 2210. Now I took a Chinese Hakko, but I can not get it done. In the photo the connections What is wrong? Thank you
How to thank sparkybg? He worked for free for an ambitious and difficult project. THANK YOU THANK YOU THANK YOU: SPARKYBG. You're an exceptional person
Mythical Sparkypg, I've been using with great satisfaction your project, and I have to thank you for your selfless work. I have a question. From the menu I put him to sleep time (10 minutes). And 'possible to insert in a soft "beep" warning that starts the sleep period? Thanks again
Finally I can post my Unisolder. That, thanks to the tireless collaboration of "tto4ka" It works perfectly. An infinite thanks to the work of "SPARKYBG"
Only problem, I would like it to work the SLEEP function. I used the same box JBC how to do?
Open Source Hardware