OK, here's what I did and found. I had to duplicate my design, delete everything but the board edge, move the board edge slightly and rename it with the GBR extension. If I didn't change the edge slightly from the original I got a "no board edge" error. Now I can get my boards in, hopefully they will be right when I get them!
Well that didn't last! One set of boards went through, the other set didn't see the GBR no matter what I did or do I can't get it to see the board edge. My Gerber viewer shows the board edge but I've used all three edge extensions with no luck.
Thanks for the reply. I did that but after reading your post I went backed and checked. I found the edge wasn't showing up so I redid the files and added an edge, they were accepted!
Hi guys, thanks for the great work! One problem we have is that our files (Labcenter Proteus) are Gerbers in .txt format. For each order we have to send emails to Jin to send them through to the board house as they get kicked out in the order. We get our boards OK but this slows down our boards and takes Jin's time. Could you figure a way to accept our txt files so we can just submit them as we order two to three time a month.
Thanks for the help, Robert Dee Design Specialties
Ian, After 10 or 15 orders from you this is still ridiculously cheap! I appreciate what you guys do an I'm amazed at how much Jin accomplishes! Raise the price!
