Ok I just found there is only one PCB in the KiCad project, so I assume the panelizing was made with an other tool, which probably works directly on the gerber files. Back to square one ;)
I just checked the files you point me and with ZofzPCB it works fine, I can see the holes. On the other hand, the web viewer doesn't show me any. I think I'll stick with ZofzPCB from now on... The web viewer doesn't seem to be able to find a outline file... [attachment=1][attachment=0]
My gerbers with the four holes can't be loaded on ZofzPCB, I believe it's because of the complexity of the polygons. Eagle warned me about the size and the complexity of the files outputed...
I'm currently downloading KiCad in order to open the original files.
I also stumble upon some forum in which some people says a milling file should be made and send to the manufacturer, but I don't think i can do that with DirtyPCBs...
Hi ! I hope you don't mind if I ask my question here, given that it's very close to the original question...
I'm also trying to make a slot in a PCB on Eagle. I've tried to do as Sjaak said : a 0 mil line on the dimension layer...[attachment=3]
I used mayhewlabs(dot)com/webGerber to preview my gerber files but it only shows me a plain rectangle instead of a rectangular hole. [attachment=2] I also tried ZofzPCB with the same results.
I'm tring to make a rectangular hole to assemble PCBs together.[attachment=1] -> [attachment=0].
I'm gonna use DirtyPCB. Could you give me a hint to find the solution ? Is it because the holes are rectangular ones ?
