1
Bus Pirate Support / Re: UART Bridge in 6.1 r1676
I will have to try it with a loop back when I have some time.
EDIT: I just thought about it. It is likely an issue with the .NET string being represented as Unicode. Testing will confirm.
Show Posts
This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.
Messages - SailingNut
I will have to try it with a loop back when I have some time.
EDIT: I just thought about it. It is likely an issue with the .NET string being represented as Unicode. Testing will confirm.
2
Bus Pirate Support / Re: UART Bridge in 6.1 r1676
It does maintain a different baud rate for the device under test.
It turns out that my program was having some issues. In .NET sending a string to the serial port like so:
Code: [Select]
sp.Write("xffxd7");
is different than sending as follows:
Code: [Select]
byte[] cmd = { 0xff, 0xd7 };
sp.Write(cmd, 0, 2);
Where sp is the serial port.
3
Bus Pirate Support / UART Bridge in 6.1 r1676
I've done a bunch of searching the forums and can't find an answer to my question.
What I want to know is when the BP is in UART bridge mode does the "device connection" (from the cable that I have attached to my device under test) retain it's previously set baud rate?
I have been able to use the terminal and manually send control codes to the LCD that I am working with, but when I enter UART bridge mode (using code that I wrote) sending the same commands fail to work properly.
TIA for any and all help!
4
Bus Pirate Support / Re: BP firmware v6.1 Hello to BootLoader Error
Has anyone figured out why the firmware won't load using priate-loader.exe? (Using Windows 7 x64 here)
I really want to "get current" on my firmware! TIA for all help!