Nevermind. I didn't look closely at the schematic there. I understand that those are all intentionally connected. Now I have to figure out what the problem really is. My L1 voltage is at 5V, so that is not the problem.
Argh. I just got around to looking at it again. I've got shorts at R10/R11, R12/R13, R14/R15, and R16/R17. I confirmed this with a multimeter. There was a lot of unhappy continuity beeping. I'm not very experienced with surface mount soldering, but I have done it before. Should I go ahead and try to fix the shorts myself or would you advise that I send it back?
