Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - aki

1
Breakout boards / Re: ATX Breakout Suggestion
... and I just noticed, as someone else has pointed out, that the standoffs for the case don't seem to be taller than the resistor. :-(
2
Breakout boards / Re: ATX Breakout Suggestion
Since the ATX PSU connector and the board have holes to bolt the connector down, would you care to suggest appropriately-sized hardware for this?  Or zip ties, perhaps?  Or do you recommend against this?

Should the load resistor be flat against the board?  (The power supply I took out of an old Gateway Pentium 2 machine needs the load resistor to start up.)  I am planning on putting it in the sick-of-beige case for it.

I'm trying to resist suggesting a small breakout board for the PSU's additional connectors that plug into the disk drives. :-)

Anyway, thank you for this design, it looks nice and will be very useful.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01572258416session_write_close ( )...(null):0
20.01612389992ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01612390768Database_MySQL->query( ).../DatabaseHandler.php:119
40.06052529488Database_MySQL->error( ).../Db-mysql.class.php:273