1
Bus Pirate Development / Bus Pirate demo board V5b parts list
Anyway, I've generated a Mouser project for it and I'd appreciate if anyone knowledgable could give it a quick look and tell me if I've done anything obviously stupid there. I'll happily hand edit rights to anyone who wants to fix it.
Notes:
- I know the zener/R3 pair aren't needed for PICKit3, and that the trace under R3 needs to be cut if these parts are installed.
- I pulled as many parts as possible from the master parts list but not D2 (zener), IC1 (op amp) or U1 ("PIC16F1829SS"). Those might need more scrutiny than the rest.
- Speaking of D2, I picked whatever seemed cheap and plentiful between 8V and 9V since that's the safe programming range according to the PIC16F1829 PDF datasheet (see Vpp range, page 361).
- Although I took it from the master parts list, I have no idea if that is an appropriate resistor network for RN1 and RN2. Please advise.
Any thoughts?