Skip to main content


This section allows you to view all Topics made by this member. Note that you can only see Topics made in areas you currently have access to.

Topics - Marais

DirtyPCBs support / Vias not connected through board
Just got my first order back from DirtyPCBs, and the boards look really good. One serious issue, though: the "vias" don't connect through the board; there are tiny pads on both sides but no electrical continuity between them. I designed the boards with KiCad and followed their examples to create the vias.

Looking for guidance on how I can determine if this is my error (most likely) or a production problem at the board house.

--- Peter
DirtyPCBs support / Board minimum dimensions
I'd like to have some boards made about 1/4" wide and say an inch or so long. Is this practical using DirtyPCB's services? Sorry if the answer is obvious- I'm new to this.

--- Peter