Skip to main content ↑ ↓

Topics

This section allows you to view all Topics made by this member. Note that you can only see Topics made in areas you currently have access to.

Topics - Monkeh

1
DirtyPCBs support / Plated (and not) slot callouts
Greetings, dirty people.

Planning to put a board through shortly with a slightly awkward USB connector on it, looking for guidance on getting the slots made correctly.

Currently I'm calling the slots out on the milling layer, with an undersized hole in the centre, and extra copper added on the bottom layer. The slots are 0.8mm diameter (already oversized).

[attachment=0]

Is this likely to come out right, or should I change to SMD pads and a bare 0.8mm drill hit in the centre of the slot?
There are also two unplated slots to the board edge, I'm unsure if those will come out right either.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01172248928session_write_close ( )...(null):0
20.01202380528ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01202381304Database_MySQL->query( ).../DatabaseHandler.php:119
40.05692520040Database_MySQL->error( ).../Db-mysql.class.php:273