Skip to main content ↑ ↓

Messages

This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.

Messages - movingbait

1
Bus Pirate Development / I2C sniffer plus/minus char meaning? solved
Solution, upgrade the firmware
http://dangerousprototypes.com/bus-pira ... i2c-guide/
    [/]  – Start/stop bit
    +/-  – ACK/NACK

Hi,

We are using the I2C sniffer at 50kHz. I am getting the '-' sign, [0xC3-] from the master. What does this means?
I have also seen some posts where there is a '+' sign, is this normal?
Any way to control the device, emulate the master to control the slave.

attached the full device ID.
Device is discovered at 50kHz when master is disconnected.
Warm Regards.

I2C>
I2C>m
4. I2C

(1)>4
Set speed:
 2. ~50KHz

(1)>2
Ready
I2C>(2)
Sniffer
Any key to exit
][0xC3-][0xC3-][0xC2-][0xC2-][0xC2-][0xC2-][0xC2-][0xC2-][0xC2-][0xC2-]

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01252253600session_write_close ( )...(null):0
20.01282385200ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01282385976Database_MySQL->query( ).../DatabaseHandler.php:119
40.05872524720Database_MySQL->error( ).../Db-mysql.class.php:273