Based on DangerousPrototypes FT2232H Schematic i assembled the components in breadboard, After when i connect the circuit to my PC it is showing "USB is not recognized".
Here i used corresponding through - hole components provided by the schematic.
For Soldering FT Chip i used QFN64 Breakout board and i connect it to breadboard by using Connecting wires.
I installed the FTDI VCP driver also, in device manager it was showing "unknown device".
Here i Attached the schematic provided by DangerousPrototypes and i attached assembled circuit in breadboard.
please let me help to how to solve this issue.