This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.
December 25, 2017, 12:59:48 pm
Use external sensorTC1047A. Sensor output connects to PA4 on 3-channel controller. Firmware Nov 24, 2017. What are the values of corTcold and setTcold that must be selected for the operation of an external temperature sensor?
December 22, 2017, 05:02:31 pm
You write - Modbus RTU protocol support (slave address modbusAd> 0). More in detail please, for what it? With the latest firmware, I stopped working with btcsv and scsvlog
July 20, 2017, 03:26:40 pm
Thank you very much for your help. I understood the temperatures. For a long time I chose PID co-factors for a "hair dryer" :). Can there be a simple, understandable method for configuring PID?
July 15, 2017, 06:46:06 pm
Could you please describe the calibration procedure in more detail?
May 02, 2017, 12:18:10 pm
All works, hurray! Many thanks for the help, the problem is solved, increased C10 (reset mcu) to 4.7uF
April 28, 2017, 10:52:43 am
Reduced the length of the wires to 4cm, added pull-up resistors 4.7k. Result - there is no image
April 28, 2017, 08:54:06 am
April 27, 2017, 10:32:25 pm
February 26, 2017, 09:01:21 am
Hi! You write - LCD 8x2 or 16x2 (for 16x2 place 2..3K resistor from LCD
to ground). D4 May be R/W ?