Skip to main content ↑ ↓

Messages

This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.

Messages - AnalogDiscoveries

1
DirtyPCBs support / Re: Are all through holes plated?
Thanks for the replies everyone, I was just a little hazy on if I need to do anything to make sure the hole was plated (I do want them to be plated), but it seems unless its a mounting hole or you specifically place a footprint without a pad then it is automatically plated.
2
DirtyPCBs support / Are all through holes plated?
Might be a stupid question, but I'm new to this, so I have lots of stupid questions!

But ya, are all through holes (ie. where components go through the board) plated automatically or do via's have to be used?

This for a rather simple 2 layer board, using kicad as the layout tool.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01592260240session_write_close ( )...(null):0
20.01642391840ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01642392616Database_MySQL->query( ).../DatabaseHandler.php:119
40.06362531360Database_MySQL->error( ).../Db-mysql.class.php:273