Skip to main content ↑ ↓

Messages

This section allows you to view all Messages made by this member. Note that you can only see Messages made in areas you currently have access to.

Messages - aki

1
Breakout boards / Re: ATX Breakout Suggestion
... and I just noticed, as someone else has pointed out, that the standoffs for the case don't seem to be taller than the resistor. :-(
2
Breakout boards / Re: ATX Breakout Suggestion
Since the ATX PSU connector and the board have holes to bolt the connector down, would you care to suggest appropriately-sized hardware for this?  Or zip ties, perhaps?  Or do you recommend against this?

Should the load resistor be flat against the board?  (The power supply I took out of an old Gateway Pentium 2 machine needs the load resistor to start up.)  I am planning on putting it in the sick-of-beige case for it.

I'm trying to resist suggesting a small breakout board for the PSU's additional connectors that plug into the disk drives. :-)

Anyway, thank you for this design, it looks nice and will be very useful.

( ! ) Fatal error: Uncaught exception 'Elk_Exception' with message 'Please try again. If you come back to this error screen, report the error to an administrator.' in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
( ! ) Elk_Exception: Please try again. If you come back to this error screen, report the error to an administrator. in /var/www/dangerousprototypes/forum/sources/database/Db-mysql.class.php on line 696
Call Stack
#TimeMemoryFunctionLocation
10.01302259328session_write_close ( )...(null):0
20.01332390928ElkArte\sources\subs\SessionHandler\DatabaseHandler->write( )...(null):0
30.01332391704Database_MySQL->query( ).../DatabaseHandler.php:119
40.05722530448Database_MySQL->error( ).../Db-mysql.class.php:273