Sick of Beige standard PCB sizes v1.0

From DP

(Difference between revisions)
Jump to: navigation , search
(List of sizes)
Line 26: Line 26:
<nowiki>*</nowiki>Note: This is not a Golden ratio rectangle, but the maximum Cadsoft Eagle PCB size for users with a free license.
<nowiki>*</nowiki>Note: This is not a Golden ratio rectangle, but the maximum Cadsoft Eagle PCB size for users with a free license.
 +
==Hardware==
 +
===Hole dimensions and locations===
 +
Holes are located in the 4 corners exactly 4mm from the vertical and the horizontal edge. They are 3.2mm in diameter.
 +
===Cooper keep-out area===
 +
Around each hole there is a cooper keep-out area approximately 5mm from the center of the hole. In this area no traces, or ground fills are aplicable, to avoid contact with metallic standoffs,and screws.
 +
===Component placement keep-off area===
 +
No component may be placed 1.7mm from an edge of the board.
 +
===Board's round corners===
 +
Each corner of the board is rounded with a 4mm radius arc.
 +
===Reference points and lines===
 +
Runing through the exact middle, both lengthwise, and lengthwise, is a reference line. Also added are two reference point for USB mini-B jack, 5.25mm for the left and right edges.

Revision as of 15:32, 26 April 2012

SOB standardsizes.png

Contents

Overview

To go along with our Sick of Beige cases we started using standard PCBs. There are two versions of varying sizes. One is a rectangle with a Golden Ratio between it's length and with, while the other is a square. All the PCBs have 4 mounting holes in each corner which are not connected to any copper on the PCB.

List of sizes

Sandard PCB Sizes
Golden Ratio Square
DP5031 50mm 31mm DP3030 30mm 30mm
DP6037 60mm 37mm DP4040 40mm 40mm
DP7043 70mm 43mm DP5050 50mm 50mm
DP8049 80mm 49mm DP6060 60mm 60mm
DP9056 90mm 56mm DP7070 70mm 70mm
DP10062 100mm 62mm DP7070 70mm 70mm
*DP10080 100mm 80mm DP8080 80mm 80mm

*Note: This is not a Golden ratio rectangle, but the maximum Cadsoft Eagle PCB size for users with a free license.

Hardware

Hole dimensions and locations

Holes are located in the 4 corners exactly 4mm from the vertical and the horizontal edge. They are 3.2mm in diameter.

Cooper keep-out area

Around each hole there is a cooper keep-out area approximately 5mm from the center of the hole. In this area no traces, or ground fills are aplicable, to avoid contact with metallic standoffs,and screws.

Component placement keep-off area

No component may be placed 1.7mm from an edge of the board.

Board's round corners

Each corner of the board is rounded with a 4mm radius arc.

Reference points and lines

Runing through the exact middle, both lengthwise, and lengthwise, is a reference line. Also added are two reference point for USB mini-B jack, 5.25mm for the left and right edges.