MCP2200 breakout board manufacturing resources
From DP
Contents |
Self test
- Download and install the MCP2200 driver, if needed
- Connect RXD and TXD on the breakout board
- Plug in the breakout board
- Find the COM port for the MCP2200 in the Windows Device Manager
- Run the self-test, verify success and LEDs when prompted
Options
--
MCP2200 TEST utility v0.1 (CC-0)
http://dangerousprototypes.com
--
Usage:
MCP2200selftest -d device [-s speed]
Example Usage: MCP2200selftest COM1
Where: -d device is port e.g. COM1
-s Speed is port Speed default is 115200
--
Help screen.
c:\>MCP2200selftest -d COM12
Example command line use.
Success
Press Esc to exit, any other key to start the self-test
Connect TXD and RXD for the self-test
Starting test!
Opening COM3 at 115200bps...
Starting self-test...
Self test PASSED!!! RX (D1) and TX (D2) LEDs should be ON
Press any key to continue...
Fail
-Starting a new Self Test-
Connect TXD and RXD for the self-test
Opening COM3 at 115200bps...
Starting self-test...
Error: bad reply (54), failed self test
Press any key to continue...
Source
This application was compiled for Windows with CODE BLOCKS 10.1 and MinGW.