MCP2200 breakout board manufacturing resources
From DP
Contents |
Self test
- Download and install the FTDI VCP driver, if needed
- Connect ADBUS0 and ADBUS1 on the FT2232 breakout board
- Plug in the breakout board
- Find the first COM port for the FT2232 in the Windows Device Manager
- Run the self-test, verify success and LEDs when prompted
Options
--
FT2232 TEST utility v0.1 (CC-0)
http://dangerousprototypes.com
--
Usage:
ft2232selftest -d device [-s speed]
Example Usage: ft2232selftest COM1
Where: -d device is port e.g. COM1
-s Speed is port Speed default is 115200
--
Help screen.
c:\>ft2232selftest -d COM12
Example command line use.
Success
--------------------- Starting a new Self Test---------------------
Connect ADBUS1 and ADBUS0 for the self-test
Opening COM12 at 115200bps...
Starting self-test...
Self test PASSED!!! RX, TX and POWER LEDs should be ON
Press any key to continue...
Connect another and press any key to start the self-test again
Or hit ESC key to stop and end the test.
Fail
Press Esc to exit, any other key to start the self-test
Connect ADBUS1 and ADBUS0 for the self-test
Starting test!
Opening com12 at 115200bps...
Starting self-test...
Error: bad reply (29), failed self test
Press any key to continue...
Connect another and press any key to start the self-test again
Or hit ESC key to stop and end the test.
Source
This application was compiled for Windows with CODE BLOCKS 10.1 and MinGW.