Logic Sniffer: OLS-loader utility

From DP

Revision as of 18:27, 1 October 2010 by Jamz (Talk | contribs)
Jump to: navigation , search

This utility is used to load new bitstreams for the FPGA. A bitstream update changes the logic that captures and stores samples.

Contents

Latest Version for this Document

       Logic Sniffer ROM loader v0.3 (September 30, 2010)


Options

  • list of -flags and options 
parameters: 
  --port PORT  - port of Logic Sniffer, needs to be specified. Same as  -p Port 
  --speed SPEED  - sets speed of the serial port. Same as -s Speed
  --wH FILE - HEX file to be uploaded to OLS
  --wB FILE - BIN file to be uploaded to OLS
  --rH FILE - HEX file to be downloaded from OLS
  --rB FILE - BIN file to be downloaded from OLS
  --l X  or -l X   - send only first X paged 
commands:
  --erase  - erases Flash, also same as using -e 
  --write  - writes data to Flash, as  -w 
  --read   - reads data from Flash, same as -r 
  --ignore_jedec  - ignore jedec id, same as -i 
  --run    - enter run mode after finished, same as -r 
  --status - get OLS status, same as -s 
  --boot   - enter bootloader mode - ignore other commands, same as -b
  --selftest - run self-test - ignore other commands



  When no command specified, program will check FW version, and Flash ID

Usage examples

Notes on command parameters

This version supports the standard long and short option commandline parameters: the short option uses a single dash ('-') followed by a single character parameter, e.g -p while a long option uses double dash ('--') followed by single word or string e.g. --port the parameters 'wH', 'wR' uses only the long option parameter e.g. --wH filename

Windows

  ols-loader --port COM2 --rH OLS.hex --read  
     its the same as 
  ols-loader -p COM2 --rH OLS.hex -r

To erase and write flash, data in BIN file 'OLS.bin', OLS on COM2: 

  ols-loader --port COM2 --wB OLS.hex --write --erase
    or for the short options parameters:
  ols-loader -p COM2 --wB OLS.hex -w -e


To get status, and jump to run mode, OLS on COM2: 

  ols-loader --port COM2 --run --status
    or for the short option parameters:
  ols-loader -p COM2 -r -s



Load ROM

Jump to bootloader 

  ols-loader --boot    
  ols-loader -b


Run selftest (long commandline option parameter only) 

  ols-loader  --selftest

Linux

The ols-code compiles without complain on debian5 build.

Command and syntax are same with windows except for the port option which uses the /dev/ttySx

OSx

Not tested

Retrieved from "http://dangerousprototypes.com/docs/Logic_Sniffer:_OLS-loader_utility"