FT2232 breakout board manufacturing resources

From DP

Revision as of 16:35, 13 December 2010 by Ian (Talk | contribs)
Jump to: navigation , search

Contents

Self test

  1. Download and install the FTDI VCP driver, if needed
  2. Connect ADBUS0 and ADBUS1 on the FT2232 breakout board
  3. Plug in the breakout board
  4. Find the first COM port for the FT2232 in the Windows Device Manager
  5. Run the self-test, verify success and LEDs when prompted

Success

------------------------------------------------------------------------
FT2232 TEST utility v0.1 (CC-0)
http://dangerousprototypes.com


Parameters used: Device = COM12,  Speed = 115200

Press Esc to exit, any other key to start the self-test

Connect ADBUS1 and ADBUS0 for the self-test

Starting test!

Opening COM12 at 115200bps...

Starting self-test...

Self test PASSED!!! RX, TX and POWER LEDs should be ON

Press any key to continue...

Connect another and press any key to start the self-test again

Or hit ESC key to stop and end the test.

Fail

Source

This application was compiled for Windows with CODE BLOCKS 10.1 and MinGW.

  • [SVN]
Retrieved from "http://dangerousprototypes.com/docs/FT2232_breakout_board_manufacturing_resources"