Bus Pirate v3 PIC 24FJ blinking LED programming tutorial

From DP

Revision as of 12:13, 26 March 2012 by Arakis (Talk | contribs)
Jump to: navigation , search

Basic get started Demo. Use the Bus Pirate V3.x to blink the user programmable MODE LED

Contents

Overview

The Bus Pirate uses the PIC24FJ64GA002 microcontrooler, and as such it can be used as a development board for the same, with some limitations. One of the pins is connected directly to the MODE LED and in this demo we will write just the basic code that is needed to blink that LED.

Basic Configuration

#include <p24fxxxx.h>
 
_CONFIG1(    JTAGEN_OFF &     //JTAG port is disabled
            GCP_OFF &         //GSP Memory Code Protection OFF
            GWRP_OFF &         //GCC Flash Write Protection OFF
            COE_OFF &         //
            FWDTEN_OFF &     //Watchdog Timer OFF
            ICS_PGx1)         //debug over PGD1 and PGC1
 
_CONFIG2(    FNOSC_FRCPLL &     //Internal FRC with PLL
            OSCIOFNC_ON &    //RA3 is clk out (fosc/2)
            POSCMOD_NONE &     //Primary oscillator disabled
            I2C1SEL_PRI)    //Use default SCL1/SDA1 pins
 
 
#pragma code

Blink the MODE LED

C30 Source Code

Retrieved from "http://dangerousprototypes.com/docs/Bus_Pirate_v3_PIC_24FJ_blinking_LED_programming_tutorial"