Bus Pirate PIC programming adapter
From DP
| Bus Pirate PIC programming adapter | |
|---|---|
| Codename | None |
| Status | Software |
| Development | development forum |
| ID # | {{{id}}} |
Contents |
Prototype
Will be available to developers shortly. Provides a 13volt supply and transistors to control it. Read more in the forum.
Schematic
PCB
Partlist
| Part | Value |
|---|---|
| C1 | 470pF capacitor (0805) |
| C2, C3, C6 | 0.1uF/50V capacitor (0805) |
| C4 | 10uF/10V capacitor (SMC_A) |
| C5 | 4.7uF/35V (SMD_A5) |
| D1, D2 | 1N5819, 20V, 1A+ diode (SOD123) |
| IC1 | MC34063AD (SO08) |
| JP1 | female 02x5 plug |
| L1 | 680uH/0.12A inductor (L4532P) |
| PIC-ICSP | 1X05 0.1” pin header |
| POWER | 1X03 0.1” pin header |
| R1 | 20K resistor (0805) |
| R2 | 2K2 resistor (0805) |
| R3 | 4R7 resistor (0805) |
| R4 | 180R resistor (0805) |
| R5 | 39K resistor (0805) |
| R6 | 100K resistor (0805) |
| R7 | 100R resistor (0805) |
| R8-R12 | 10K resistor (0805) |
| T1, T2 | NPN, 200mA+, 30+hfe transistor (SOT23-BEC) |
| T3,T4 | PNP, 600mA+, 40+ hef transistor (SOT23-BEC) |
Manufacturing test
This design will use a Bus Pirate v3 to check the output voltage of the boost converter.
- Final version should measure MCLR after VPP!
HVP Self Test Utility
Description
HVP selftest utility is intended for manufacturers to test and verify the voltage output level at the assembly line. This one should calculate the actual voltage (>12volts passes test) (49K/10K resistor divider, 3.3volt reference) taken from the Bus Pirate voltage probe measurement.
Current Version
Bus Pirate HVP Adapter SELF TEST utility v0.1 (CC-0) http://www.dangerousprototypes.com
Usage
Help Menu
-------------------------------------------------------------------------
Usage:
hvpselftest -p device
Example Usage: hvpselftest COM1 -R
Where: -p device is port e.g. COM1
-s Speed is port Speed default is 115200
-------------------------------------------------------------------------
Note about this Utility
The simple selptest utility set the buspirate to enter the binary bitbang mode first, then configure the pins as output by sending '01000000' to it, and then send '1100000' to set the power on,then send '00010100' for the voltage probe measurement, and take a reading from the 2 bytes reply.