Bus Pirate Edu Kit Exercise no.11
From DP
(Difference between revisions)
(→The Circuit) |
|||
| Line 4: | Line 4: | ||
==The Circuit== | ==The Circuit== | ||
[[Image:BP_EK_E11_schematic.jpg|300px]][[Image:BP_EK_E11_circuit.jpg|300px]] | [[Image:BP_EK_E11_schematic.jpg|300px]][[Image:BP_EK_E11_circuit.jpg|300px]] | ||
| + | |||
| + | ===Breadboard legend=== | ||
| + | {| class="wikitable" border = "1" | ||
| + | ! IC Location !! Breadboard wiring legend | ||
| + | |- | ||
| + | | | ||
| + | {| border = "1" | ||
| + | ! IC !! PIN1 (+) !! PIN2 (-) | ||
| + | |- | ||
| + | | MCP7940M || E14 || E15 | ||
| + | |- | ||
| + | | 32KHz crystal || C14 || C15 | ||
| + | |- | ||
| + | | C1 || BB_-_left || B14 | ||
| + | |- | ||
| + | | C2 || BB_-_left || B15 | ||
| + | |} | ||
| + | || | ||
| + | {| border = "1" | ||
| + | ! Signal name !! Contact1 !! Contact2 | ||
| + | |- | ||
| + | | 5V || BP_5V || BB_+_left | ||
| + | |- | ||
| + | | 5V || BB_+_left || BB_+_right | ||
| + | |- | ||
| + | | 5V || BB_+_right || J14 | ||
| + | |- | ||
| + | | 5V || BP_VPU || BB_+_left | ||
| + | |- | ||
| + | | GND || BP_GND || BB_-_left | ||
| + | |- | ||
| + | | GND || BB_-_left || A17 | ||
| + | |- | ||
| + | | MOSI || BP_MOSI || J17 | ||
| + | |- | ||
| + | | CLK || BP_CLK || J16 | ||
| + | |} | ||
| + | |} | ||
| + | *The (+) and (-) next to PIN1 and PIN2 are intended for devices such as LEDs, where PIN1 should be the anode and connected to a higher potential then PIN2. | ||
==Bus Pirate Terminal== | ==Bus Pirate Terminal== | ||
==Not Working?== | ==Not Working?== | ||
==Taking it further== | ==Taking it further== | ||
Revision as of 14:19, 12 April 2013
Contents |
Overview
The Circuit
Breadboard legend
| IC Location | Breadboard wiring legend | ||||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
- The (+) and (-) next to PIN1 and PIN2 are intended for devices such as LEDs, where PIN1 should be the anode and connected to a higher potential then PIN2.
