Modifying a computer ATX power supply for higher output voltage

ATXBasedBatteryCharger1

Kerry Wong wrote a post on his blog showing how he modified the 12V rail of a TL494 based ATX power supply to 14.6V for 4S LiFePO4 battery charging:

To charge the 110Ah battery bank I built, I need a power supply that can provide at least 10A at 14.6V. Since I have many old ATX power supplies lying around and the 12V rails of these power supplies are more than capable of providing 10A, I decided to modify one such power supply for using as a 4S LiFePO4 battery charger.

More details at his blog here.

Check out the video after the break.

Join the Conversation

1 Comment

  1. This shows how to disable the OVP circuit and increase the output voltage. This does not make a battery charger, you need a constant current rather than foldback current limit, it should turn off when the battery is full, and 14.6V will kill a 4S LiFePO4. 13.8V is much better, 14.2V at most, and 14.4V at what the OVP should be set to.

Leave a comment

Leave a Reply to Blars Cancel reply

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.