Categories

App note: Safety considerations and layout recommendations for digital isolators

Posted on Sunday, April 23rd, 2017 in app notes by DP

an_silabs_AN583

Application note from Silicon Labs about end user safety against high voltage shock that are designed together with digital isolators. Link here (PDF)

This application note details the creepage and clearance requirements of an isolator type component, such as a digital isolator, used to provide protection from electric shock. It also details layout recommendations to enhance a design’s robustness and ensure compliance with end safety standards.

This entry was posted on Sunday, April 23rd, 2017 at 1:25 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “App note: Safety considerations and layout recommendations for digital isolators”

  1. Max says:

    Jolly good stuff, although the “include 100 W resistors in series with the inputs and outputs” part is quite hilarious until one realizes* they meant “Ohm” (probably ran out of “O”, “”h” and “m” letters and had a surplus of “W” – hey, it can happen to the best of us…).

    * Yes, I do realize “W” is occasionally used instead of “Ω”; I just find that practice particularly snobby and indefensible when three other letter can do the job equally well with much less chance of confusion.

Leave a Reply to Max

Click here to cancel reply.

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!