MSP430 Bootloader by Dylek for value line series (RS232)

Posted on Thursday, February 5th, 2015 in MSP430 by DP


Daniel Duchna made his own MSP430 Bootloader and wrote a detailed description in his WIKI.

It is as simple as usage of any other Bootloader. Firstly you have to flash ‘MSP430 Bootloader by Dylek’ to MCU.
You can do it through ‘MSP430 Flasher’ provided by Texas Instruments on their WIKI


This entry was posted on Thursday, February 5th, 2015 at 2:07 pm and is filed under MSP430. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

6 Responses to “MSP430 Bootloader by Dylek for value line series (RS232)”

  1. f4grx says:

    Setting all ports to output is a problem. This will not play nicely with all peripherals and default pin state of main firmware, moreover there is no need to do it. Apart from that, nice project!

  2. Erik Ratcliffe says:

    Nice! I’m going to have to play with this soon. Two value line Launchpads are gathering dust on my shelf, and this sounds like a good enough excuse to rev one up.

  3. dylek says:

    You may be right not all configurations of peripherals will work correctly.
    So what do you suggest ?
    Should I leave them as floating input ?

  4. f4grx says:


    Thanks for responding. Yes, letting the lines float is what I would do. This is the configuration that has the smallest influence on a running system.

    This lets anyone set the port value before setting the line to output. This is important, because in some designs you don’t want a glitch on some lines.

  5. dylek says:

    Will do it shortly in next update.

  6. pj says:

    Most MSP430 devices contain a bootstrap loader in ROM:

    However, when you can get a LaunchPad development board with dedicated program *and* debug capabilities for $10 (and well-supported by open-source tools) it is a no-brainer to go that route.

Leave a Reply to dylek

Click here to cancel reply.

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!