Categories

Power line communication

Posted on Thursday, April 10th, 2014 in AVR, data transfer by DP

power-line-communication

Haris Andrianakis wrote a post on his blog detailing his power line communication system:

The main purpose was to implement two devices communicating each other, using the technology of power line. Specifically, at this project the communication has been used to send data from a weight bridge/ weight machine to a remote display. For the power line communication has been chosen the ST7540 modem. ATmega168 is holding the protocol stack and controls the modem. The data are sent to ATmega168 via UART which converts and transfers them using SPI to ST7540. ST7540 is responsible for the Power Line transmission.

Check out the video after the break.

This entry was posted on Thursday, April 10th, 2014 at 9:00 pm and is filed under AVR, data transfer. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Power line communication”

  1. Dhruv Patel says:

    Really interesting!!!

  2. Ever says:

    I would like to provide me the diagram, please.

Leave a Reply to Ever

Click here to cancel reply.

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please