HV Nixie DC-DC switching power supply

photo_1

Michail Papadimitriou over at Electronics Lab designed a simple DC-DC switching regulator capable of powering most of Nixie tubes:

The module is based on the MAX1771 Step-Up DC-DC Controller. This controller works up to 300kHz switching frequency and that allows the usage of miniature surface mount components. It accepts an input voltage from 2 to 16.5V and the output is factory configured to 12V. In this module the output voltage is configured higher at ~180Vdc using external resistors and a potentiometer.

The MAX1771 is driving an external N-channel MOSFET and with the help of the inductor and a fast diode, high voltage is produced.
MOSFET has to be RDSon, Diode has to be fast Mttr, typically < 50nS and capacitors has to be low ESR to have good efficiency.

Join the Conversation

5 Comments

  1. Hm, I think both guys should look into isolation distances and guidelines for high and low voltage on the same board.
    The ground plane clearance around the high voltage outputs on both boards really bothers me!

Leave a comment

Leave a Reply to Xevel Cancel reply

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.