Open source hardware GPIB USB adapter update

kMQgJkFl

Steven Casagrande posted an update on his open source hardware GPIB USB adapter:

After many days, I just finished off firmware version 5 for my adapter. This is probably my biggest update yet. A lot of people asked for compatibility with the Prologix commands so that’s what I focused on. Here is an overview of the new firmware:

  • Nearly all Prologix command set support. The adapter should now work with some pre-existing software tools and examples on the internet that were originally intended. Some will require a few changes for baud rate and flow control settings
  • Improved termination character handling
  • SRQ support (but no parallel polling, only serial)
  • Improved stability
  • Device mode (first version so there may be fixes in the future)
  • Most settings can be stored in EEPROM
  • Basic FIFO buffer for data sent from the PC

Via the forum.

Join the Conversation

3 Comments

    1. So it works and it doesn’t at the same time. It found that his software requires the use of the RTS/CTS hardware control lines by default. In addition, it is set to use a different baudrate.

      Both problems can be fixed by recompiling his software. In addition, the baudrate problem can be fixed by playing with a registry key used by the FTDI driver to map the baudrates. I think you can also make an entry in a config file for the toolkit for the baudrate part. I haven’t tried that one though.

      The biggest though is the RTS/CTS requirement. I’ve been in contact with John about the issue and I recommended he add an option to not use those control lines.

Leave a comment

Leave a Reply to Drone Cancel reply

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.