Categories

Accurate-ish Pneumatic cylinder positioning with flow meter, ATX breakout and MSP430 LaunchPad

Posted on Friday, October 18th, 2013 in ATX BB, DIY, MSP430 by DP

SAM_0803

arduinoversusevil writes:

We’re using the 43oh to control 12V solenoids supplied from a Dangerous Prototypes ATX breakout, and the Adafruit flow meter is feeding back position data to the 43oh. Surprisingly IT WORKS! For more build deets visit the blog

Check out the video after the break.

This entry was posted on Friday, October 18th, 2013 at 12:25 pm and is filed under ATX BB, DIY, MSP430. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “Accurate-ish Pneumatic cylinder positioning with flow meter, ATX breakout and MSP430 LaunchPad”

  1. kerimil says:

    He should provide more specs about that cylinder – if we assume that cylinder is 6cm diameter then we get roughly 14.1ccm volume per 5mm stroke (that’s what he could achieve). Now that does sound impressive until you realize that for a 1.5 cm diameter the same 14.1ccm translates to 8cm of stroke. Though sticktion would make it more of a problem for smaller diam. cylinders so it’s going to get worse.

    It might be a better idea to investigate Hall effect sensors instead. Try ss495b

  2. superUnknown says:

    Thanks for the tip.
    3″ diameter. sticktivity is an issue, but I still got a few trick up my sleeve.

Leave a Reply to kerimil

Click here to cancel reply.

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...