Categories

OpenBench Logic Sniffer ported to Pipistrello LX45

Posted on Monday, September 16th, 2013 in Logic Sniffer by DP

POLS2s

mkarlsson ported the Open Bench Logic Sniffer code to run on Pipistrello LX45:

FYI, I have ported the Demon 3.07 code to Pipistrello LX45 FPGA board with the following changes:

1) The sample buffer size is increased by a factor of 8 from 24kB to 192kB
2) The interface is changed to serial (Pipistrello uses a FTDI 2232H High-speed USB chip)
3) The baud rate is increased from 115200 to 921600 to reduce the data upload time
4) The meta data has changed to indicated Pipistello implementation

I believe this is the largest buffer size of any of the “SUMP” implementations. It runs great with the latest JaWi OLS Java client.

Via the forum.

Get a Logic Sniffer for $50, with free worldwide shipping.

This entry was posted on Monday, September 16th, 2013 at 11:04 am and is filed under Logic Sniffer. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “OpenBench Logic Sniffer ported to Pipistrello LX45”

  1. ken says:

    Hmm…200MHz sampling.

    A Pipistrello LX45 is $150: http://saanlima.com/store/index.php?route=product/product&product_id=51

    Still need probes (not sure where to get them) for a logic analyzer…

Leave a Reply to udif

Click here to cancel reply.

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please