Categories

New Bus Pirate probe cable

Posted on Thursday, September 1st, 2011 in Bus Pirate, Bus Pirate accessories by Ian

Seeed Studio has a new Bus Pirate probe cable in stock. It has female pins instead of clips, and the wire is thicker and higher-quality.

We prefer the female pins for plugging into pin headers on dev-boards. To interface another female header, like the Arduino, just pop a male header in between. Best of all, there’s a variety of high quality test hooks that you can add to the cable.

The new probe cable is available for $5,95.

This entry was posted on Thursday, September 1st, 2011 at 12:36 pm and is filed under Bus Pirate, Bus Pirate accessories. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

4 Responses to “New Bus Pirate probe cable”

  1. Chris says:

    Good news, the original Seeed bus pirate cable was shonky. Picture seems to show some headers pushed into the socket though?

  2. Graham Bloice says:

    Doesn’t show up in stock for me. I have a few bits in my cart just waiting for this.

  3. rsdio says:

    Can you buy this ticker wire separately? (I’m just making a joke about the typo)

Leave a Reply to Chris

Click here to cancel reply.

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • gant: They still have a couple of the more expensive (but still considerably cheap) 5S-I-S01 in stock...
  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!