Bus Pirate v3.8 free PCB build

in builds by DP | 2 comments

BtA1MgjCAAAWQDu

@psmay tweeted picture of his free Bus Pirate v3.8 PCB build:

If you build a free PCB we’ll send you another one! Blog about it, post a picture on Flicker, whatever – we’ll send you a coupon code for the free PCB drawer.

Get your own handy Bus Pirate for $30, including world-wide shipping. Also available from our friendly distributors.

This entry was posted in builds and tagged , .

Comments

  1. Peter S. May says:

    Note that it isn’t quite finished, but it’s at least close.

    I don’t have any solder paste on hand, so I used a conventional soldering iron to tin all of the pads on the board, then tacked all of the parts into place with a generous blob of flux paste. After a bit of 375°F on the electric skillet and a little nudging, about three-fourths of the board was correct, but a few of the smaller parts floated away and had to be replaced and soldered by hand (very tricky with those 0603s and my wobbly hands). After some cleanup with an iron, a wick, and the hot air rework tool borrowed at Club Cyberia, all of the components were in place, but the thing didn’t work.

    I didn’t realize until I got home that the FT232RL was placed in reverse (as shown in the picture), and there’s a good chance that this was the only problem, though I’m sure the USB connector being full of flux isn’t helping.

    I plan to finish it off next time I’m there, which is hopefully next weekend.

  2. Peter S. May says:

    Finished the board today. Ruined two FT232RLs in the process—my SSOP soldering technique is rather clumsy—but finally I was able to program the bootloader with my PICkit 2, add the firmware with pirate-loader_lnx, and run the self-test, which passed after I made the requisite connections (had to watch out for the 3.8 pinout not matching previous versions; I scrambled the colors of the jumper wires to match the 3.6 card). Sweet.

Leave a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Notify me of followup comments via e-mail. You can also subscribe without commenting.