Pushing VLAN tags through unmanaged switches

in tcpip by DP | 2 comments

2014-03-13 19.47.41

Kenneth Finnegan writes:

This year, I was designated as the computer network zonie, so it’s my job to make sure that there’s IP connectivity between all the major sites in the network. This involves building a computer network that includes a couple Internet hand-off points, multiple routers, several medium-range (2-5km) microwave links, QoS enforcement for a few hundred devices to support VoIP and streaming video while sharing a 15Mbps Internet uplink, a couple 802.1Q VLAN trunks, etc.
Needless to say, we are building a network beyond the budget we’re being given, so duct tape and Linksys devices are being applied liberally throughout this project.

One problem we’ve encountered this year is that we need a few network devices to be on the same layer two network while being two miles apart. These two sites don’t have line of sight, so we’re using two microwave links to bounce off a third site between them, while these links also need to carry a few other L2 domains. A perfect application for VLAN tagging.

This entry was posted in tcpip and tagged , .

Comments

  1. eLLi says:

    Why is this posted in the “Wireless” category? The concern of the article is VLAN tagging and finding the maximum supported MTU sizes of some 10/100MBit switches and their respective Debian/Linux drivers. That’s just related to general Tcp/Ip networking, with or without wires. Thus, the correct category should be “Tcpip”.

Leave a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Notify me of followup comments via e-mail. You can also subscribe without commenting.