TM220A pick and place
Experimenting will probably continue all day. A sturdier table is going to be a must.
This entry was posted in #liveupdates and tagged TM220A.
In The Forum
- Open Bench Logic Sniffer • Re: How do I? tkg
- Open Bench Logic Sniffer • Re: Corrupted flash memory? tkg
- Open Bench Logic Sniffer • Re: Update mode is not activated tkg
- Tools of the trade • Re: b.braun or Edson flux , anyone know where to get it. Sjaak
- Tools of the trade • Re: Cutting mylar stencils with a silohuette cameo pmonta
- Bus Pirate Development • Composition about winter Winter mountaineering to aavmmipm
Comments
I would like to see a video in action!
Agreed. A video and some screen snap would be nice.
I’m using a MadelTech DP2006 at work, integrating a vision system (up and down). Works very well but a little bit slow with small parts. Could be interesting to use a TM220 along for Res and Caps.
Yes, please!
Also, it would be nice if you could show how to program the thing.
Its coming. Let me figure bit put myself then share in Thursdays workshop video.
The pick and place machines we had at work years ago actually required quite a bit of mass under them (one larger one needed almost 20 kg) to help minimize sway even after we had them on super study tables… something to think about.
Just take a couple of L-brackets and sink some screw anchors into the wall. Fasten the table to the wall using wing-nuts to the L-brackets, so you can remove them easily and move the table. This will add the needed stability to your table. This will even work with dry wall if you provide enough anchors.
Pick and place. Serious geek cred.