PCB a Week 5: Oledy generic OLED breakout board

in PCBs, project logs by DP | 1 comment

oledy-gerber

Mats continues his challenge of designing one PCB every week. In week 5 he came up with Oledy, a breakout board featuring 8 most common pitches for OLED display connectors, spanning from 0.5mm to 1mm.

The Oledy board is a 5×5 cm board meant to be cut in half ending up with two boards 2.5 x 5 cm. Each board have a two 16-pin headers that are connected to four arrays of 32 solder pads. All eight pad arrays are of different pitch to match different OLED displays. The piches are 0.50, 0.60, 0.62, 0.65, 0.70, 0.80, 0.845 and 1.00 mm

Via the forum.

This entry was posted in PCBs, project logs and tagged , , .

Comments

  1. Sleepwalker3 says:

    I want one :D

Leave a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Notify me of followup comments via e-mail. You can also subscribe without commenting.