Si4707 weather band receiver IC breakout board

in project logs, RF by DP | 1 comment

AIW designed a breakout board for the Si4707 weather band receiver IC. It features a coax antenna connector, and I2C pins broken out and pulled high to 3.3V. Code sample for interfacing the device to the Arduino was released in the forum.

I do have comms utilizing Arduino I2C bus. The Si4707 is 3.3V so I have the arduino 3.3V output tied to VCC,VIO and to the I2C pull-up resistors. No audio yet because I haven’t bread boarded the audio amp circuit yet, but I am able to do the following: power up, get rev, set frequency, and wb tune status.

Via the forum.

This entry was posted in project logs, RF and tagged , , .

Comments

  1. ReidC says:

    Is that an autograph I see on the board?

Leave a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Notify me of followup comments via e-mail. You can also subscribe without commenting.