Using tape as a solder paste stencil

in DIY by DP | 0 comments

Sjaak shared his experiment using two L-shaped pieces of tape as a solder paste stencil. After he applied the solder paste he separated some of it using a knife.

as expected to much paste was applied as the opening was the size of the chip. I expect better result if the opening was the same size as the exposed pad or little less (also depends on the chipsize)

Via the forum.

This entry was posted in DIY and tagged , , .

Leave a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Notify me of followup comments via e-mail. You can also subscribe without commenting.