Punnet cardboard cut-out case for the Raspberry Pi
It doesn’t get much simpler than this cardboard case for the Raspberry-Pi. It’s a printable cut-out design that shows you where to cut, bend, and glue to make a simple enclosure.
While this isn’t the most professional looking enclosure for a project, it does provide some protection. We’d like to design DIY cutout cases for some for our projects as too.
Via Raspberry Pi.
This entry was posted in cases and tagged cardboard, case, Raspberry Pi.
Comments
I’ve actually made this case and it’s really easy to make up, although I didn’t have a craft knife so I had to use a small kitchen knife (very slowly and carefully) and a ruler and it turned out great. I did one with paper and then another with red cardboard and a custom design which had the RPi logo on it. I’ll try to post a picture later to show it. Sadly the paper one I made before is slightly deformed as the cat took off with it!