Transistor tester powerd from 2 AA batteries

in Part Ninja, project logs by DP | 2 comments

Ferdinand added a dc/dc converter circuit to the transistor tester, allowing it to be powered from 2 AA batteries instead of a single 9volt. This project is similar to our Part Ninja, it’s designed to test various electronic components like transistors, diodes, resistors, etc, and display their pin out and basic specifications.

I built my own version of this handy tool last weekend. I replaced the linear regulator with a small boost-converter. Now the circuit can be powered with two AA batteries.

The PCB is sandwiched between the battery holder and LCD, so to provide a handy device without need for a case. I had a lot of fun designing and building the circuit, so thank you DP for highlighting this project.

Be sure to check out our video describing the Part Ninja project.

Via the forum.

This entry was posted in Part Ninja, project logs and tagged , .

Comments

  1. Cahyo says:

    Good Job And Thank’s Information …

  2. Ali Adil says:

    sir can i hav its circuit diagram ? ? ? plz sir

Leave a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Notify me of followup comments via e-mail. You can also subscribe without commenting.