FIRMWARE UPDATE: USB and Serial LCD Backpack v1.1 beta 1

in firmware, Status update by DP | 0 comments

A new test firmware is available for the USB and Serial LCD Backpack. This update fixes some compatibility problems with the LCDproc software, and integrates the separate USB and serial mode firmwares.

  • Now replies to 3 commands used by LCDproc that were not implemented before (replies 0x00 to commands 5,6,7) . This caused some problems for Linux users
  • Serial and USB modes are now integrated into a single firmware. If no USB connection is detected after 5 seconds the board defaults to UART mode (9600bps fixed)

Grab the beta from the forum, update instructions are available here. Any test reports are greatly appreciated.

Get your own USB LCD Backpack for $16.95 at Seeed Studio.

Via the forum.

This entry was posted in firmware, Status update and tagged , , .

Leave a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Notify me of followup comments via e-mail. You can also subscribe without commenting.